Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

Valek
  • Locked
  • Question Question
Basic Dimension
Replies
5
Views
244
CheckerHater
CheckerHater
Jieve
  • Locked
  • Question Question
ISO Position GD&T and Dimensioning Questions
2 3
Replies
42
Views
816
CheckerHater
CheckerHater
SpaciouS
  • Locked
  • Question Question
Datum set-up and referencing
Replies
6
Views
235
fsincox
fsincox
PRuggiero
  • Locked
  • Question Question
Ordinate Dimensioning
2
Replies
23
Views
832
tz101
tz101
DanieJones
  • Locked
  • Question Question
Composite position on non-patterned features
Replies
7
Views
164
SeasonLee
SeasonLee
cwdaniel
  • Locked
  • Question Question
Odd metric thread call out
Replies
17
Views
550
cwdaniel
cwdaniel
Jieve
  • Locked
  • Question Question
Flatness w/ Perpedicularity and parallelism redundant?
Replies
3
Views
322
Jieve
Jieve
JasonNicholson
  • Locked
  • Question Question
How to Deal with Multiple Datum Reference Frames
Replies
7
Views
556
fsincox
fsincox
fiambre
  • Locked
  • Question Question
Why and how basic dimensions?
Replies
3
Views
235
KENAT
KENAT
MadMango
  • Locked
  • Question Question
Thread Call-outs
Replies
18
Views
1K
fcsuper
fcsuper
AaronRodgers
  • Locked
  • Question Question
Same dimension value, different feature
Replies
15
Views
1K
fsincox
fsincox
Jieve
  • Locked
  • Question Question
Perpendicularity vs. Title Block Angle Tolerance
2
Replies
23
Views
710
fsincox
fsincox
greenimi
  • Locked
  • Question Question
Translate into GD and T language: How? Which is the best way?
2
Replies
35
Views
484
greenimi
greenimi
shaneg
  • Locked
  • Question Question
Slot position
Replies
2
Views
110
fsincox
fsincox
indkitty
  • Locked
  • Question Question
2mm offset
Replies
6
Views
245
indkitty
indkitty
Jieve
  • Locked
  • Question Question
position tolerance for hole at end of long shaft
Replies
5
Views
390
Jieve
Jieve
ejthoma2
  • Locked
  • Question Question
Roundness vs diameter for Tolerance Stack
Replies
11
Views
896
Belanger
Belanger
Jieve
  • Locked
  • Question Question
GD&T Datum Selection
Replies
10
Views
1K
Jieve
Jieve
flash3780
  • Locked
  • Question Question
How to define a feature that isn't in the nominal profile
Replies
10
Views
240
MechNorth
MechNorth
JasonNicholson
  • Locked
  • Question Question
Verification of a GDT Use
Replies
4
Views
199
pmarc
pmarc
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top