Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

Madhu454
  • Locked
  • Question Question
M Modifier V/S Envelope Rule
Replies
0
Views
79
Madhu454
Madhu454
cjccmc
  • Locked
  • Question Question
Minimum size for datum feature
Replies
2
Views
284
cjccmc
cjccmc
Madhu454
  • Locked
  • Question Question
How to establish the Datum-C ?
Replies
13
Views
253
aldumoul
aldumoul
aldumoul
  • Locked
  • Question Question
Positional Tolerancing
2
Replies
20
Views
403
aldumoul
aldumoul
prdave00
  • Locked
  • Question Question
Surface profile decision, allow less accuarte clocking
Replies
2
Views
133
SeasonLee
SeasonLee
prdave00
  • Locked
  • Question Question
True position of sphere
Replies
7
Views
454
fsincox
fsincox
brandnew1
  • Locked
  • Question Question
Question regarding True Position Callouts
Replies
5
Views
143
fsincox
fsincox
cjccmc
  • Locked
  • Question Question
Combining Position and Perpendicular
Replies
7
Views
335
Belanger
Belanger
M
  • Locked
  • Question Question
Basic dimension puzzler
Replies
3
Views
155
Belanger
Belanger
fsincox
  • Locked
  • Question Question
A Minimum Surface Finish Requirements For Bolted Joints?
Replies
2
Views
119
MintJulep
M
dansullivan2001
  • Locked
  • Question Question
Geometric tolerancing squareness of holes
Replies
1
Views
166
pmarc
pmarc
jimbod20
  • Locked
  • Question Question
Casting Definition via GD&T
Replies
9
Views
189
Tunalover
Tunalover
Dave K
  • Locked
  • Question Question
Parts list/BOM standard
Replies
2
Views
325
Dave K
Dave K
oldbob16
  • Locked
  • Question Question
control of cylindrical features with intersecting axes
Replies
6
Views
349
ak762
ak762
Rich29662
  • Locked
  • Question Question
Drawing note
Replies
4
Views
181
CheckerHater
CheckerHater
vonsteimel
  • Locked
  • Question Question
Who accepts final responsability for a drawing; the Certified Drafter or the Engineer that checks it
2
Replies
34
Views
1K
nobog
nobog
kneeslider
  • Locked
  • Question Question
TOLERANCE BLOCK
Replies
15
Views
2K
Belanger
Belanger
timidlikerivers
  • Locked
  • Question Question
GD&T Standards by country
Replies
8
Views
327
CheckerHater
CheckerHater
bxbzq
  • Locked
  • Question Question
pin hole pattern as datum offset from CL
Replies
9
Views
319
pmarc
pmarc
mschroeder
  • Locked
  • Question Question
Basic bolt circle diameter dim. Does it control bolt pattern runout to a center?
2
Replies
21
Views
742
CheckerHater
CheckerHater
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top