Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Positional Tolerancing

Status
Not open for further replies.
aldumoul

aldumoul

Mechanical
Joined
May 24, 2011
Messages
65
Location
US
Am I able to remove the Feature Control Frame from the Datum C hole? Or can I remove Datum C altogether and have the Feature Control Frame to Datums A and B only (left side view)? If so, can I add bonus tolerancing from Datum B to the Ø.573/553 holes?

 
Sort by date Sort by votes
If it is theoertical, I cannot see the logic because you may have the holes out of position to the theoeritcally perfect position, yet they can function together just fine (twist the part to the right, etc.)
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

YNIEH
  • Question Question
Dimensioning and Tolerancing Block ASME Y14.1
Replies
2
Views
599
3DDave
3DDave
MPSU
  • Locked
  • Question Question
Positional tolerance twice for same Stud
Replies
12
Views
3K
MPSU
MPSU
AMontembeault
  • Locked
  • Question Question
Multiple Single Segment Positional Tol and Datums
Replies
7
Views
1K
3DDave
3DDave
MPSU
  • Locked
  • Question Question
Positional Tolerance of a Corner profile
Replies
7
Views
764
Doug Hunter
Doug Hunter
MattEdwards
  • Locked
  • Question Question
Tolerancing 'flush'
Replies
7
Views
2K
Ryan6338
Ryan6338

Part and Inventory Search

Sponsor

Back
Top