Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

bxbzq
  • Locked
  • Question Question
datum set on mounting surface of linear motion guide
Replies
2
Views
271
fsincox
fsincox
dstokesag
  • Locked
  • Question Question
Perpendicularity of a flange surface to a bore ID datum
Replies
15
Views
878
jflongwell
jflongwell
vonsteimel
  • Locked
  • Question Question
Proper Callout for Centerdrills
2
Replies
24
Views
2K
vonsteimel
vonsteimel
bxbzq
  • Locked
  • Question Question
How to control features separately
2 3
Replies
52
Views
702
pmarc
pmarc
jeff97070
  • Locked
  • Question Question
Is "typical opposite side" still legal?
Replies
19
Views
655
fsincox
fsincox
JMorton99
  • Locked
  • Question Question
Surface Datums
Replies
4
Views
99
axym
axym
JMorton99
  • Locked
  • Question Question
Defining Positional Tolerance of Hole Using Surface Datum
Replies
7
Views
375
3DDave
3DDave
ModulusCT
  • Locked
  • Question Question
Simple Question about Centerlines
Replies
11
Views
1K
powerhound
powerhound
MrGearhead
  • Locked
  • Question Question
Avoiding Redundacy
Replies
8
Views
469
TWJR
TWJR
MaSaav
  • Locked
  • Question Question
Drawing revision
Replies
2
Views
209
KENAT
KENAT
UchidaDS
  • Locked
  • Question Question
"Standard" to Change Drawing Template and Add Notes
Replies
10
Views
275
KENAT
KENAT
roywu2002
  • Locked
  • Question Question
Dimensional tolerance MIN question
Replies
8
Views
591
ewh
ewh
ModulusCT
  • Locked
  • Question Question
Free State Requirement for a dim without a FCF?
Replies
13
Views
275
ModulusCT
ModulusCT
gabimo
  • Locked
  • Question Question
What is the ô"tertiary datum problem"?
Replies
9
Views
323
3DDave
3DDave
ModulusCT
  • Locked
  • Question Question
Break sharp edge within a surface profile zone...
Replies
4
Views
343
ModulusCT
ModulusCT
boottmills
  • Locked
  • Question Question
Hole pattern dimensions question
Replies
8
Views
643
Tunalover
Tunalover
MrGearhead
  • Locked
  • Question Question
Basic ASME Drafting Questions
Replies
3
Views
499
Tunalover
Tunalover
dtmbiz
  • Locked
  • Question Question
ASME Y14.5 vs. ISO; concept of applying dimensions
Replies
12
Views
1K
CheckerHater
CheckerHater
UchidaDS
  • Locked
  • Question Question
Supplier drawing to own drawing template/part number
Replies
3
Views
132
KENAT
KENAT
engineerbecca
  • Locked
  • Question Question
ASME Drawing Standards: Altered Item or New Revision?
Replies
6
Views
934
engineerbecca
engineerbecca
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top