Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

bxbzq
  • Locked
  • Question Question
inspection friendly dimensioning
Replies
1
Views
110
axym
axym
greenimi
  • Locked
  • Question Question
Perpendicularity of a spring?
Replies
2
Views
381
btrueblood
btrueblood
jayk77
  • Locked
  • Question Question
Demonstrate symmetry in structural drawing
Replies
4
Views
169
KENAT
KENAT
Nereth1
  • Locked
  • Question Question
GD&T: Maximum angular misalignment of two bearing mounts on a shaft
Replies
16
Views
1K
Nereth1
Nereth1
LONDONDERRY
  • Locked
  • Question Question
Machine shops and metric drawings
2
Replies
28
Views
795
KENAT
KENAT
sluzzer
  • Locked
  • Question Question
Substitute for Projected Tolerance?
Replies
12
Views
176
powerhound
powerhound
Raddy13
  • Locked
  • Question Question
Using cast hole as a datum
Replies
11
Views
457
hdsi44
hdsi44
DerbyLoco
  • Locked
  • Question Question
Call up of symmetry on drawings
Replies
7
Views
1K
CheckerHater
CheckerHater
HightechHillbilly
  • Locked
  • Question Question
GD&T on a Hex Bar
Replies
12
Views
645
drawoh
drawoh
RooneyJC
  • Locked
  • Question Question
Question about dimensioning with center-plane datums
Replies
11
Views
900
powerhound
powerhound
STeliczan
  • Locked
  • Question Question
Why dimension sheet metal flat patterns?
2
Replies
23
Views
791
btrueblood
btrueblood
duk748
  • Locked
  • Question Question
eco or ecn form
Replies
6
Views
234
dgallup
dgallup
bxbzq
  • Locked
  • Question Question
Use part of contour controlled by all around profile as datume features
Replies
5
Views
93
Tarator
Tarator
bxbzq
  • Locked
  • Question Question
what is the difference between continuous feature and pattern feature
Replies
14
Views
576
ModulusCT
ModulusCT
Manifolddesigner
  • Locked
  • Question Question
Din tolerances on an ASME drawing?
Replies
1
Views
172
CheckerHater
CheckerHater
sluzzer
  • Locked
  • Question Question
How the bonus tolerance which we get by Material conditions are used during manufacturing?
2
Replies
21
Views
883
ModulusCT
ModulusCT
CTengineer2012
  • Locked
  • Question Question
Runout Symbol Question
Replies
7
Views
921
Belanger
Belanger
powerhound
  • Locked
  • Question Question
Customized DRF
Replies
8
Views
197
CheckerHater
CheckerHater
Vimalmechs
  • Locked
  • Question Question
doubt about perpendicularity in diameter application.
Replies
10
Views
401
pmarc
pmarc
thepete
  • Locked
  • Question Question
multi segment question
Replies
15
Views
536
Belanger
Belanger
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top