Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

greenimi
  • Locked
  • Question Question
Compound datum feature A(M)-B(M) used as a primary
2
Replies
23
Views
448
pmarc
pmarc
UchidaDS
  • Locked
  • Question Question
"BASIC" Dimension tolerance in First Article Inspection Report-continue
Replies
9
Views
248
pmarc
pmarc
marshell
  • Locked
  • Question Question
Drawing scale call out for isometric drawings
Replies
9
Views
1K
3DDave
3DDave
wunntj
  • Locked
  • Question Question
Balloon Location
Replies
3
Views
293
wunntj
wunntj
dezignr
  • Locked
  • Question Question
Boundary on slotted features
Replies
9
Views
963
dezignr
dezignr
Dawg2012
  • Locked
  • Question Question
Clarify correct usage of the Dimension Origin symbol
Replies
9
Views
870
pmarc
pmarc
urkson
  • Locked
  • Question Question
Basic Dimensions
2
Replies
33
Views
2K
juergenwt
juergenwt
urkson
  • Locked
  • Question Question
Datums and centerlines
2
Replies
27
Views
1K
SeasonLee
SeasonLee
jflongwell
  • Locked
  • Question Question
Selecting a Basic dimension as a datum
Replies
10
Views
920
pmarc
pmarc
vonsteimel
  • Locked
  • Question Question
Brain fart Monday: Question about dimensioning
Replies
6
Views
137
vonsteimel
vonsteimel
ingallspw
  • Locked
  • Question Question
Dimension GD&T of a complex nylon / plastic parts.
Replies
6
Views
283
ingallspw
ingallspw
Twullf
  • Locked
  • Question Question
JS tolerance questions
Replies
4
Views
533
CheckerHater
CheckerHater
ska7ch
  • Locked
  • Question Question
Advice for this part please and a couple of other niggling questions - ISO/BS8888
Replies
4
Views
118
CoryPad
CoryPad
UchidaDS
  • Locked
  • Question Question
Note sequence in drawing
Replies
15
Views
906
drawoh
drawoh
UchidaDS
  • Locked
  • Question Question
Break sharp edges
Replies
11
Views
2K
ewh
ewh
SeasonLee
  • Locked
  • Question Question
ISO surface roughness symbol to and FG
Replies
5
Views
420
SeasonLee
SeasonLee
Dimensionalstuff
  • Locked
  • Question Question
standard call out for controlling Slot feature as per ISO and ASME
Replies
9
Views
2K
KENAT
KENAT
Daave
  • Locked
  • Question Question
4-Hole Feature Pattern to create two centered Datums, incorrect or not?
Replies
3
Views
105
KENAT
KENAT
JHG1981
  • Locked
  • Question Question
GD&T training
Replies
8
Views
203
KENAT
KENAT
dragonfire613
  • Locked
  • Question Question
Proper callout of view for multiple locations.
Replies
12
Views
1K
lwealing
lwealing
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top