Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

hobbs101
  • Locked
  • Question Question
confusion over basic dimensions
Replies
19
Views
2K
CheckerHater
CheckerHater
BraunP
  • Locked
  • Question Question
Straightness tolerance on a piece of sheetmetal
2
Replies
24
Views
1K
BraunP
BraunP
kgwhipp
  • Locked
  • Question Question
GD&T (or other) callout
Replies
1
Views
111
3DDave
3DDave
3DDave
  • Locked
  • Question Question
This is what I mean by misrepresenting the subject matter.
Replies
10
Views
109
axym
axym
ronj100
  • Locked
  • Question Question
Does this callout also keep -c- parallel to pattern?
Replies
7
Views
239
fsincox
fsincox
SDETERS
  • Locked
  • Question Question
Specifying a datum on a cored hole
Replies
5
Views
175
ak762
ak762
TheRealDeal55
  • Locked
  • Question Question
Drafting border not at 0,0
Replies
2
Views
107
looslib
looslib
sooner1031
  • Locked
  • Question Question
Rule #1 Question - Implied Flatness
Replies
5
Views
574
sooner1031
sooner1031
ELister
  • Locked
  • Question Question
New to GD&T - Could someone take a look at a drawing ive done?
Replies
18
Views
173
ELister
ELister
AMontembeault
  • Locked
  • Question Question
Standards help
Replies
3
Views
148
ewh
ewh
UchidaDS
  • Locked
  • Question Question
Wetted Holes
Replies
4
Views
220
drawoh
drawoh
BraunP
  • Locked
  • Question Question
Revision and pages
Replies
11
Views
722
KENAT
KENAT
Tunalover
  • Locked
  • Question Question
Assigning datum features to hole patterns
Replies
16
Views
780
pmarc
pmarc
Tunalover
  • Locked
  • Question Question
Question on controlling form and position of irregular features
Replies
3
Views
90
Tunalover
Tunalover
happystamps
  • Locked
  • Question Question
Differentiating between surface of shaft/hole and axis
Replies
7
Views
378
Tenkan
Tenkan
bxbzq
  • Locked
  • Question Question
RFS and Projected tolerance zone concept on threaded holes
Replies
13
Views
1K
greenimi
greenimi
bxbzq
  • Locked
  • Question Question
part drawing revision and assembly drawing revision
Replies
12
Views
1K
KENAT
KENAT
hygear
  • Locked
  • Question Question
"Global" GD&T Standard?
2
Replies
26
Views
888
juergenwt
juergenwt
rsm7400
  • Locked
  • Question Question
Flatness Callout Question
Replies
8
Views
239
Gilmiril
Gilmiril
AMontembeault
  • Locked
  • Question Question
Quantity callouts
Replies
15
Views
2K
Gilmiril
Gilmiril
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top