Pro/INTRALINK 3.0 Upgrade: SAFE?
Pro/INTRALINK 3.0 Upgrade: SAFE?
(OP)
I am thinking of upgrading from Pro/I 2.0 2000140 to Pro/I 3.0 20001020. I have messed around with the build and have looked at all the TANS SPR's and stuff like this.
Are there any reasons not to upgrade??????
I hate unhappy upgrades
Are there any reasons not to upgrade??????
I hate unhappy upgrades

RE: Pro/INTRALINK 3.0 Upgrade: SAFE?
RE: Pro/INTRALINK 3.0 Upgrade: SAFE?
Do you know of any issues with this release?
I "heard" that Pro/I 3 can corrupt Pro/E data.
Have you heard the same?
RE: Pro/INTRALINK 3.0 Upgrade: SAFE?
Family tables are a big problem along with a VERY slow workspace. These are known by PTC and a new build is expected sometime in February. I haven't corrupted any files, but you can corrupt a workspace if you don't include generics and instatnces during checkout. This is a major pain due to the PTC Library of fasteners. One assembly checkout will yield about 2,000 to 4,000 parts.
I would wait for a build later then 2001360!
John
RE: Pro/INTRALINK 3.0 Upgrade: SAFE?
Daniel Pro/E Specialist
http://www.torgon.com/