Hi!
I did some small changes on my machine.
It is a virtual Win7 machine, and I moved to a new host,
first all went fine, but after update of vmware-tools, I stuck in troubles.
When I make a new sketch and constrain it to the geometry and change the view orientation or only the zoom,
than the sketch and the existing geometry are moving in the room without any sense and any connection.
I think, I had this problem some years before, and there is an easy solution, but I can't find a note ....:-(
Does somebody know the solution?
Greetings,
Holger
H.Steffen
I did some small changes on my machine.
It is a virtual Win7 machine, and I moved to a new host,
first all went fine, but after update of vmware-tools, I stuck in troubles.
When I make a new sketch and constrain it to the geometry and change the view orientation or only the zoom,
than the sketch and the existing geometry are moving in the room without any sense and any connection.
I think, I had this problem some years before, and there is an easy solution, but I can't find a note ....:-(
Does somebody know the solution?
Greetings,
Holger
H.Steffen