Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Surface cracking after liquid nitriding in 16MnCr5 Material

Status
Not open for further replies.

Best Nitriding

Industrial
Joined
Sep 28, 2023
Messages
1
Location
IN
Hello sirs,

With the reference to the following subjected information Surface cracking after liquid nitriding thread332-296883, like wise we also identified the cracks in MPI from 0.21 - 0.24mm depth after liquid nitriding process of 16MnCr5 shaft. The process cycle is followed as 1. Cleaning 2. Pre-Heating @ 400°C - 1 Hour soaking 3. Liquid Nitriding @ 565°C - 6 Hours with carbonate of 19% 4. Water Quenching immediate (5 Mins) from liquid bath 5. Post Washing & Cleaning 6. Oxidation @400°C - 30 Mins
7. Water Quenching ( Separate ) immediate from oxidation bath 8. Washing & Cleaning 9. Inspection 10. Dispatch. The photographic samples of analysis is attached. Pls give suggestions.

Thanking you.
[URL unfurl="true"]https://res.cloudinary.com/engineering-com/image/upload/v1695882321/tips/Cracks_Micro_didaqa.bmp[/url][URL unfurl="true"]https://res.cloudinary.com/engineering-com/image/upload/v1695882321/tips/Cracks_1_q1r96a.bmp[/url][URL unfurl="true"]https://res.cloudinary.com/engineering-com/image/upload/v1695882323/tips/Cracks_ewgexr.bmp[/url]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top