Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
thread569-257657 Hi, I got th
- Thread starter MechDU
- Start date
Please provide more information to suggest anything that might help in troubleshooting. The provided information is not sufficient. May be you can post a snap of model setup and stress/displacement plot.
-What is the element type?
-Is the element quality good that is whether max aspect ratio is less than 10 and other quality parameters within range?
-What is analysis type? static/transient, structural/thermal and/or implicit/explicit?
-How are you defining load step increments? What are the load magnitudes?
-How the stress/displacement plot of last converged step looks?( Is is reasonable/realistic as expected?)
-What is the element type?
-Is the element quality good that is whether max aspect ratio is less than 10 and other quality parameters within range?
-What is analysis type? static/transient, structural/thermal and/or implicit/explicit?
-How are you defining load step increments? What are the load magnitudes?
-How the stress/displacement plot of last converged step looks?( Is is reasonable/realistic as expected?)
- Status
Similar threads
- Locked
- Question
- Locked
- Question