Gear Design
Gear Design
(OP)
Hi,
I have been asked to "Model a helical worm 'crown gear' for a single start worm thread placed 'radially' and prepare AUTOCAD drawing". I am trying to model a hellical crown gear and 'somehow' fit a worm gear placed radially on it.
What do I actually have to make and how to make it?
Any leads would be appreciated.
I have been asked to "Model a helical worm 'crown gear' for a single start worm thread placed 'radially' and prepare AUTOCAD drawing". I am trying to model a hellical crown gear and 'somehow' fit a worm gear placed radially on it.
What do I actually have to make and how to make it?
Any leads would be appreciated.
RE: Gear Design
If it's a regular worm gear then you need to specify the diameter and the ratio of the worm wheel to the worm gear.
See
https://khkgears.net/product-category/worm-gear-pa... and
http://www.roymech.co.uk/Useful_Tables/Drive/Worm_...
RE: Gear Design
RE: Gear Design
RE: Gear Design
RE: Gear Design
RE: Gear Design