Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

WRC 107 nozzle calculations

Status
Not open for further replies.

Mech2325

Mechanical
Joined
May 2, 2016
Messages
99
Location
PK
Can anyone tell if PV ELITE considers pipe undertolerance while performing WRC calculations for nozzles?

When I run the analysis, it does take the pipe undertolerance while performing internal pressure calculations for nozzle, but for WRC, I saw in the report that the software has mentioned nominal thickness
I did not find any option to manually enter the nozzle thickness in WRC tab

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top