Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

New Postprocessor has different X and Y moves between Fanuc and Heidenhain posts with postbuilder

Status
Not open for further replies.

bongoman

Mechanical
Joined
Sep 14, 2006
Messages
78
Location
US
Hi All,

I have a question on creating new 5 axis table-table posts in postbuilder.
If I create a new 5-axis table-table post with library Fanuc control and another with the library Heidenhain control and set up machine XYZAC the same in both I get different X and Y moves but the same A and C moves. Does anyone know why this is? The heidenhain control outputs the same XYZ data that is in the CLSF output but the Fanuc post does not. The machine Kinematics have been set identically.

Thanks,
Rick D.

Win7 64 bit w/NX10.0.3.5 MP19 and NX11.0.2 MP3
Vericut 8.0
 
 http://files.engineering.com/getfile.aspx?folder=3d198e07-2dd4-4f55-8b7a-aae1d87665a5&file=5_axis_output.txt
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top