Error: Failed to find baud and parity

anass DRT · Feb 15, 2017

hello
plz i need your help as soon as possible.
i can't connect to slc5/04 i have always this message"failed to find baud and parity.."
i use cable USB-174-CP33
i don't have this program offline.
i change error to CRC , i change full to half duplex no thing happen .
plz help .!!

IRstuff · Feb 15, 2017

Did you actually change the baud rate?

TTFN (ta ta for now)
I can do absolutely anything. I'm an expert!

https://www.youtube.com/watch?v=BKorP55Aqvg

faq731-376 forum1529 Entire Forum list

http://www.eng-tips.com/forumlist.cfm

John2025 · Feb 15, 2017

Is it a new cable? Flipping the transmit and receive wires is a possibility.

jcaden · Feb 26, 2017

Look at computer-properties-hardware-device manager. Look for Ports. Your USB port should show up. Click on it and check if the "Device is Working Properly". Check the baud rate,parity, etc settings, as well as the Com port number. Match them with the RS-Linx settings.

Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Error: Failed to find baud and parity

anass DRT

Electrical

IRstuff

Aerospace

John2025

Industrial

jcaden

Electrical

Similar threads

Part and Inventory Search

Sponsor