Amada pulsar
Amada pulsar
(OP)
Long time lurker I have a fairly new mazak camp with a manual focus which we use for light gauge 24 ga ss... I've acquired an Amada pulsar with 2000 watts and I am trying to cut heavy stuff!! So when cutting .25" I get a pretty good cut using e3 for a cut condition... Now cutting 3/16 I have a problem I changed the cut condition to the appropriate 4.5mm and when piercing we are getting a lot of blow back and too much heat on holes- What's wrong
RE: Amada pulsar
RE: Amada pulsar