Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Red film on inside of laser mirrors and channels. 1

Status
Not open for further replies.
herb777

herb777

Mechanical
May 5, 2006
1
I have a Mitsubishi LC10 Laser. There is a heavy build up of a red film inside the mirror housings as well as on the mirrors. Can anyone tell me what this is from. We cleaned and aligned all mirrors about 1000 hours ago and all was fine.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Herb,

I am not familiar with the LC10 laser, but I do recall that we had a problem with our laser beam on a 3020 LXP clipping the inside of the beam path bellows, which resulted in an odd colored film on the bend mirrors and mirror housings.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

ScottHaselden
  • Locked
  • Question
calculator for Angle tolerance based on Angularity of leg length
Replies
0
Views
1K
ScottHaselden
ScottHaselden
Ohuti
  • Locked
  • Question
Failure of shaft analysis specififically through mechanical engineering calculations
Replies
1
Views
2K
BEMPE16524
BEMPE16524
JEMG
  • Locked
  • Question
Question on all forces being applied on the attached.
Replies
1
Views
311
desertfox
desertfox
yrrh
  • Locked
  • Question
Locknut and screw problem
Replies
1
Views
774
SkipVought
SkipVought
bryjarmoc
  • Locked
  • Question
Justification of Manufacturing Engineering for a Company 2
Replies
3
Views
1K
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top Bottom