Hi,
I am running a sol 111 restart and I am using XYPUNCH to output QUAD4 stress components (RM & IP). How do I get the results to be output in the material coordinate system?
Normally if I request STRESS(PUNCH)=ALL in my subcases and I use PARAM,OMID,YES in the BULK section, I get the stresses in the material coordinate system.
If I leave PARAM,OMID,YES in the BULK section but use XYPUNCH instead of STRESS(PUNCH)=ALL, I get the XYPUNCH results in the element coordinate system. Does anyone know how to get around this? Thanks for any advice you can provide!
I am running a sol 111 restart and I am using XYPUNCH to output QUAD4 stress components (RM & IP). How do I get the results to be output in the material coordinate system?
Normally if I request STRESS(PUNCH)=ALL in my subcases and I use PARAM,OMID,YES in the BULK section, I get the stresses in the material coordinate system.
If I leave PARAM,OMID,YES in the BULK section but use XYPUNCH instead of STRESS(PUNCH)=ALL, I get the XYPUNCH results in the element coordinate system. Does anyone know how to get around this? Thanks for any advice you can provide!
