Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Worst case tolerance for diameter
- Thread starter Benny1976
- Start date
Benny1976,
Are you studying GD&T?
As per Rule[ ]#1, the maximum allowable diameter is .3735".
The minimum acceptable measurement across your diameter is .372". Circularity and runout refine your diameter tolerance. If you can measure .372" at one position, and .3725" at some other position, your part is not round enough. Trying to convert GD&T back into [±][ ]tolerances is futile.
--
JHG
Are you studying GD&T?
As per Rule[ ]#1, the maximum allowable diameter is .3735".
The minimum acceptable measurement across your diameter is .372". Circularity and runout refine your diameter tolerance. If you can measure .372" at one position, and .3725" at some other position, your part is not round enough. Trying to convert GD&T back into [±][ ]tolerances is futile.
--
JHG
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Question