Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SE2607 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Wood Shear Walls near Stairs

Status
Not open for further replies.

Supun93

Structural
Nov 28, 2019
35
Hi. I need to design shear walls for a 2 story building. My questions is how to design the shear walls near stairs.
Screenshot_2024-07-10_181551_r5judd.jpg
Can we put the shear line as shown in the image for the ground floor. If we put that then how i going to design the footings? Do i need to put two footings there? Outer one to withstand gravity loads coming from roof and inner footing to bear the shear loads? Please give me your opinion. Thanks
 
Replies continue below

Recommended for you

why not just use the upper right wall as both a bearing & shear wall?
 
Yes. We can use that. What if we cannot use that wall?Lets say wall length in right side is too small. How can we add the shear wall?
 
One of two scenarios:

1) You're using full height studs because there's no floor diaphragm there to brace them, so your shear wall is two stories high.

2) You design a wind girt to support the wall at what would otherwise be a hinge.

In both cases, you need to get load out of the second floor diaphragm and into your walls. This will happen with a collector. It's typically the the rim board or the top plate of the lower wall. So the diaphragm transfer in that area to the upper right has to be sufficient to dump the load into that collector, and then the collector has to deliver it to that first floor shear wall. Presumably the roof diaphragm load is going straight through the stacked walls.

Then, if you want to really design it properly, you need to consider sub/transfer diaphragms to get the load from the the main diaphragm out past the re-entrant corner formed by the stair.
 
You can always use the bottom wall of the stairs as a shear wall. That's what I would do to sleep better and it is hard to mess up by the contractor. That wall should be 1 story high.
 
For footings of interior shear walls I generally put a grade beam. This provides mass for the overturning resistance, adequate anchorage for hold downs.

Depending on the overturning and HD forces I might look at a stemwall with cont. spread footing.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor