Wild Fire 3.0 m130 on Windows 7 64 bit

[PAZMAN66]

i'M Ttrying to Install Pro/ENGINEER wILDFIRE 3.0 M130 for windows 2000 and xp


on a new box running WINDOWS 7 64 bit. Please advise.


Does anyone know if this will work?

Thanks in Advance,


Paul
Edited by: PAZMAN66

 

[bobscad]

I have installed wildfire 3.0 on my laptop running windows pro 7 64 bit and


it runs fine. Not sure if it will run with windows 7 home 64 bit, but you can get the


upgrade to windows pro and it should be good to go.

 

[PAZMAN66]

Thanks.





I'm off maintenance with Pro/e having trouble getting a licence file.


Just looking for a heads up before I begin the process.

 

[bobscad]

even if your maintance has expired you should be able to get a new licence file.


I you bought Pro/E and have your old maintance account number that will show


that you purchased it at some point and they should give you a new licence file.


I recomend you get a USB network plug and use that mac address for your


licence and use the USB like a "dongle" so you dont need to get a new licence


file when you switch computers. Thanks what I've done and I can install pro/e


on whatever I want but it only runs if the "dongle" is plugged into that machine.


good luck