Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Why no PERSPECTIVE Views allowed in Drafting?
- Thread starter uncleho
- Start date
You can do this, but maybe not as easily as mid-range CAD programs can do.
From the Modeling application, orient your part/model to the desired view and apply any other settings necessary. Once you have the part/model the way you want it to look, save the view (View -> Operation -> Save As) and give the view a unique name that is NOT a canned view name that's already being used.
Now go over to Drafting and create an imported view using the named view you created in Modeling.
If that's not what you want, then you're going to have to give an example.
Tim Flater
Senior Designer
Enkei America, Inc.
From the Modeling application, orient your part/model to the desired view and apply any other settings necessary. Once you have the part/model the way you want it to look, save the view (View -> Operation -> Save As) and give the view a unique name that is NOT a canned view name that's already being used.
Now go over to Drafting and create an imported view using the named view you created in Modeling.
If that's not what you want, then you're going to have to give an example.
Tim Flater
Senior Designer
Enkei America, Inc.
- Thread starter
- #3
My mistake....I was thinking of adding a view OTHER than the canned views.
NX doesn't allow for perspective views in Drafting...not sure why anyone would want one either because the dimensioning would be all out of whack. What in the world are you wanting a perspective view in Drafting for?
Tim Flater
Senior Designer
Enkei America, Inc.
NX doesn't allow for perspective views in Drafting...not sure why anyone would want one either because the dimensioning would be all out of whack. What in the world are you wanting a perspective view in Drafting for?
Tim Flater
Senior Designer
Enkei America, Inc.
- Thread starter
- #5
JohnRBaker
Mechanical
Starting in NX 3, any non-orthogonal view on a drawing can be set to be in Perspective. Just select the boundary of the view, press MB3 and select Style and go to the tab labeled "Perspective" and toggle on the "Perspective" option. You can also set the distance factor to control the extent of the "vanishing point" effect.
John R. Baker, P.E.
Product "Evangelist"
NX Product Line
UGS Corp
Cypress, CA
Phone: 714-952-6032
FAX: 714-952-5758
John.R.Baker@ugs.com
John R. Baker, P.E.
Product "Evangelist"
NX Product Line
UGS Corp
Cypress, CA
Phone: 714-952-6032
FAX: 714-952-5758
John.R.Baker@ugs.com
- Status
