Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
What's the standrad of worm and worm gear drafting?
- Thread starter Kimo05
- Start date
CheckerHater
Mechanical
If you are in ISO part of the world you may be interested in:
ISO 701:1998 International gear notation -- Symbols for geometrical data
ISO 1122-1:1998 Vocabulary of gear terms -- Part 1: Definitions related to geometry
ISO 1122-2:1999 Vocabulary of gear terms -- Part 2: Definitions related to worm gear geometry
Kimo05,
You should chat with your manufacturers. A lot of manufacturers like to make custom worm gears as a set in which you call up the tooth clearance. Either the manufacturer makes both pieces, or you supply the off-the-shelf worm you intend to use.
They can also tell you what standard they like to follow.
--
JHG
You should chat with your manufacturers. A lot of manufacturers like to make custom worm gears as a set in which you call up the tooth clearance. Either the manufacturer makes both pieces, or you supply the off-the-shelf worm you intend to use.
They can also tell you what standard they like to follow.
--
JHG
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
