Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

What is the alternate for Geometric Properties command in NX8.5

Status
Not open for further replies.

NXsupport

Computer
Joined
Apr 11, 2008
Messages
251
Location
US
Hi All,

Looks like the Geometric Property tool under Analysis is now gone.. Only way to get to it is through Command Finder..

What is the alternate to it? its an awesome tool..
 
Try...

Analysis -> Local Radius...

BTW, if you had moved your cursor over the 'Geometric Properties...' item once it was added back on the pull-down menu the 'bubble help' that would come-up would have made that suggestion.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.
 
Hi John,

The old Geo Prop tool used work across Entire Assembly.. But the new one works on work part only.. I tried to toggle the selection intent tool bar to change the focus to Entire Assembly, its not available..

 
That is true. Perhaps this would be a good time to ask for an Enhancement.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.
 
I'm going to try and open a PR to see if I can get any action going the route.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top