Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
what is 'INC=500' meant? 1
- Thread starter mambo5
- Start date
-
1
- #2
I assume you do not have access to ABAQUS Documentation and in particular to ABAQUS Keywords Reference Manual. Therefore, I copy-pasted the description of INC parameter:
"INC
Set this parameter equal to the maximum number of increments in a step (or in a single loading cycle for direct cyclic analysis). This value is only an upper bound. The default value is 100.
The INC parameter has no effect in procedures where automatic incrementation cannot be used (for example, *BUCKLE, *STEADY STATE DYNAMICS, and *MODAL DYNAMIC).
"
(I think that is not a message but rather a copy of a STEP definition from the input file.)
"INC
Set this parameter equal to the maximum number of increments in a step (or in a single loading cycle for direct cyclic analysis). This value is only an upper bound. The default value is 100.
The INC parameter has no effect in procedures where automatic incrementation cannot be used (for example, *BUCKLE, *STEADY STATE DYNAMICS, and *MODAL DYNAMIC).
"
(I think that is not a message but rather a copy of a STEP definition from the input file.)
- Status
Similar threads
- Question
- Locked
- Question
- Question