Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
What does this error message mean during constrain attempt 2
- Thread starter Aubreyair
- Start date
-
2
- #2
This is best described with a tree....
but
Loop design is exactly that...You make and external reference to Part A from Part B. You get the loop error when you then try to make an external reference to Part B from A.
You need to be careful and manage your external references.
One way to get around this is to create and wireframe and create your references individually to the wireframe. Wireframe is at the top. In other cases where one part must reference another, just be concious of what your are doing and know the dependencies.
Hope that helped you out...good luck!
but
Loop design is exactly that...You make and external reference to Part A from Part B. You get the loop error when you then try to make an external reference to Part B from A.
You need to be careful and manage your external references.
One way to get around this is to create and wireframe and create your references individually to the wireframe. Wireframe is at the top. In other cases where one part must reference another, just be concious of what your are doing and know the dependencies.
Hope that helped you out...good luck!
- Status
Similar threads
- Question