WHAT DOES THIS ERROR MEAN?

[nmiltner]

I am setting up template parts, and when adding annotations, and ID symbols, I sometimes get an error that says "annotation specified connot have an associative origin". If I OK the error and then try to place the symbol or note again it works. This occurs when creating the symbol or note with a leader line.

I am using NX5.

 

[uwam2ie]

... NX504 ? update to 5.05 then its fixed

 

[ewh]

That used to happen often to me when I would try to place the annotation or symbol inside of a view boundary, close to a boundary edge. I think it has been fixed, as uwam2ie posts.

"Good to know you got shoes to wear when you find the floor." - [small]Robert Hunter[/small]

 

[nmiltner]

Actually we are at 5.0.3