herriotwatt
Materials
Does anyone know if ASME B31.4 allows the use of weldolets as branch fittings?
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Weldolets and ASME B31.4
- Thread starter herriotwatt
- Start date
- Status
Yes, per ASME B31.4 section 404.3 "Intersections". Review this entire section carefully to check for proper area reinforcement. Also, make sure the weldolet is properly specified for the pressure/temperature rating for your application. I would suggest visiting the web site below for additional information on weldolet fittings;
- Status
Similar threads
- Locked
- Question
- Question
- Locked
- Question
