Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

WELDING REINFORCEMENT

Status
Not open for further replies.

WHGRO

Mechanical
Oct 30, 2001
2
US
I HAVE A "ELBOWLET" TO INSTALL. THE ELBOW IS 6" SCH 80 SA234 WPB AND THE ELBOWLET OUTLET SIZE IS 2" SOCKET WELD. THE ELBOWLET IS RATED 6000# AND IS CONSTRUCTED OF SA105 MATERIAL.
THE ELBOWLET IS TO BE INSTALLED USING ASME SECTION B31.1 AND 31.3 REQUIREMENTS FOR INTERGRE. REINFORCED BRANCH CONNECTIONS.
DOES ANYONE HAVE A WELDING DETAIL FOR "ELBOWLETS WITH THE REQUIRED REINFORCEMENT SHOWN? THIS WOULD BE SOMEWHAT DIFFERENT FROM THE STANDARD SOCKOLETS SHOWN IN CODE BOOK AS THE CONFIGURATION IS DIFFERENT.
ANY HELP WITH THIS WILL BE APPRECIATED.



 
Replies continue below

Recommended for you

WHGRO
Show detail your referring to. Do you believe there is a
special weld profile needed ???

Cosmic-Pigg
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top