S
scolil
Guest
Fillet weld, one plate has 3 holes in a line. I want one stitch in between each pair of holes.
When I model this the weld goes along the entire junction. If I change it to an intermittent weld, the weld starts on one end. How do I get the weld to start the stitch at a given distance? Or is there a better way to locate the weld?
When I model this the weld goes along the entire junction. If I change it to an intermittent weld, the weld starts on one end. How do I get the weld to start the stitch at a given distance? Or is there a better way to locate the weld?
