Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Welding a Lifting Lug to a Paddle Blind
- Thread starter ianertia
- Start date
bimr,
There is a big difference between a "Blind Flange (shown in your Video) and the "Paddle Blind" the OP asked about.
The Paddle Blind should have (1) a welded on tongue with a hole for a crane hook or (2) a drilled and tapped hole (in the rim) for a lifting Pin.
Sometimes its possible to do all the right things and still get bad results
There is a big difference between a "Blind Flange (shown in your Video) and the "Paddle Blind" the OP asked about.
The Paddle Blind should have (1) a welded on tongue with a hole for a crane hook or (2) a drilled and tapped hole (in the rim) for a lifting Pin.
Sometimes its possible to do all the right things and still get bad results
- Status
Similar threads
- Question
- Question
- Question
