Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Weld symbols (UK BS8888)

Status
Not open for further replies.
SiW979

SiW979

Mechanical
Joined
Nov 16, 2007
Messages
804
Location
GB
Hi

I was wondering if anyone could tell me whether or not is acceptable to place weld symbols on ISO (or similar) drawing views? Or should all weld symbols be placed on the orthangonal views?

Many thanks

Si

Best regards

Simon NX 7.5.4.4 MP8 and NX 8.5 (native) - TC 8
 
Status
Not open for further replies.

Similar threads

J
  • Question Question
Position Tolerance on placed objects on a weldment
2
Replies
35
Views
8K
jamiethekiller
J
Galvano
  • Locked
  • Question Question
Welding symbols
Replies
12
Views
5K
MintJulep
M
Nescius
  • Locked
  • Question Question
GD&T symbols themselves - is there any official guidance about their shape and proportions?
Replies
10
Views
546
Nescius
Nescius
tw_0407
  • Locked
  • Question Question
Tolerancing of member prints (weldment/riveted assembly members)
Replies
5
Views
430
MintJulep
M
skrowdilos_resu
  • Locked
  • Question Question
Weldment assembly, GD&T to make surface parallel to hole pattern?
Replies
2
Views
335
S-eng
S

Part and Inventory Search

Sponsor

Back
Top