Weld Symbol

[Egnorant]

I am welding two plates that are at right angle to each other as shown on the attached. I am not sure how to show the groove weld symbol. Could somebody check whether the symbols shown are correct. I want the welded edge on the right hand side to be flushed/smooth by grinding. Thanks

 

[JStructsteel]

I think what you show works, but I think instead of a G, dont you just draw a horizontal line for flush?

 

[JLNJ]

Without looking it up, I believe the horizontal line is for flush and the G is for grind smooth.

 

[JStructsteel]

Might be best to add a tail note then

 

[WinelandV]

My personal opinion, but I'd be inclined to show a top view and call the welds out there.

Please note that is a "v" (as in Violin) not a "y".

 

[Egnorant]

Thanks a lot