Jul 20, 2013 #1 Zrob Structural Joined Aug 4, 2007 Messages 47 I have figured most of these settings out except this one. Anyone know how to adjust this spacing? AutoCAD and UGS NX 5 & 7 User South Coast Mass
I have figured most of these settings out except this one. Anyone know how to adjust this spacing? AutoCAD and UGS NX 5 & 7 User South Coast Mass
Jul 20, 2013 #2 JohnRBaker Mechanical Joined Jun 1, 2006 Messages 38,223 Location US At least with respect to NX 7.0, have you tried changing the 'Weld Space Factor' setting in the 'Settings' section of the Weld Symbol dialog? John R. Baker, P.E. Product 'Evangelist' Product Engineering Software Siemens PLM Software Inc. Industry Sector Cypress, CA Siemens PLM: UG/NX Museum: To an Engineer, the glass is twice as big as it needs to be. Upvote 0 Downvote
At least with respect to NX 7.0, have you tried changing the 'Weld Space Factor' setting in the 'Settings' section of the Weld Symbol dialog? John R. Baker, P.E. Product 'Evangelist' Product Engineering Software Siemens PLM Software Inc. Industry Sector Cypress, CA Siemens PLM: UG/NX Museum: To an Engineer, the glass is twice as big as it needs to be.
Jul 20, 2013 Thread starter #3 Zrob Structural Joined Aug 4, 2007 Messages 47 I did not notice it or try it, but I will check that out on Monday. Thanks. AutoCAD and UGS NX 5 & 7 User South Coast Mass Upvote 0 Downvote
I did not notice it or try it, but I will check that out on Monday. Thanks. AutoCAD and UGS NX 5 & 7 User South Coast Mass