W
wildfirebrigade
Guest
I would like to measure weight distribution of the wheels
of a vehicle. I tried this by mating the vehicle as a body
on a floor (ground) using general connections. The CoG of
the vehicle is not in the middle at all, but the measured
normal forces of the wheels & floor are all the same.
Whats going on??
Im useing WF5 & MDX
of a vehicle. I tried this by mating the vehicle as a body
on a floor (ground) using general connections. The CoG of
the vehicle is not in the middle at all, but the measured
normal forces of the wheels & floor are all the same.
Whats going on??
Im useing WF5 & MDX