Is there a way to shut off "Fix at Timestamp". I keep turning it off, but when I start a new session or switch from one part to another it is back on. This has come back to bite me when I make a change in the base part, but then discover the wave linked part has not changed. I am on NX 8.5
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Wave Linking - Fix at Current Timestamp
- Thread starter flam04
- Start date
gelsonnicoletto
Mechanical
Hello,
In the customer Defaults > Modeling > Feature Parameters >
Extract and WAVE Geometry Linker
You can change the default command option.
Gelson Z. Nicoletto
Eng. Supervisor
Mould Desing
Brazil
In the customer Defaults > Modeling > Feature Parameters >
Extract and WAVE Geometry Linker
You can change the default command option.
Gelson Z. Nicoletto
Eng. Supervisor
Mould Desing
Brazil
- Status