View Update Report Error

[Jashe]

I've attached a screen shot of a window that pops up when I try to create a section view from a part I received as a Product and then I generated a part file from the product. Is anybody familiar with this message? I've never seen it before.

 

[drewmumaw]

@Jashe
Does the view then show a small red "x"? It might be because there is a part far off in space. It could also because the section plane does not cut through the solid.

Drew Mumaw

http://www.textsketcher.com

http://www.drewmumaw.com

 

[Jashe]

It did show a red X. The window that pops up actually tells you what body is the problem so I had to recreate the body and then it did let me create the section view after that.

 

[JeniaL]

this happens to me too with a simple models. when i recreate a body everything goes well