Is there a valve available that would adjust the amount of flow in a hydraulic line, based on the signal received from an electronic device? <br><br>I am currently planning on running it into a PLC, but if a valve is available, then I would like to bypass the PLC.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
valving in hydraulic operation
- Thread starter ksuengrng
- Start date
ksuengrng;<br><br>Look in the Designers Guide at <A HREF=" TARGET="_new"> to see a list of all manufacturers of flow controls. You should look at the ones listed as Proportional Flow Controls.<br><br>Regards:<br><br>Bud Trinkel<br><A HREF=" TARGET="_new"> <p>Bud Trinkel<br><a href=mailto:fluidpwr@evansville.net>fluidpwr@evansville.net</a><br><a href= Power Solutions</a><br>33+ years experience in hydraulic and pneumatic circut design, troubleshooting and training.
- Status
Similar threads
