Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

UW-11(C)

Status
Not open for further replies.
212197

212197

Mechanical
Joined
Jun 2, 2007
Messages
124
Location
IN
as per UW-11(C),no RT is required for external pressure vessel. What's the rationale?
 
Sort by date Sort by votes
Weld seams are generally in compression.

Regards,

Mike

The problem with sloppy work is that the supply FAR EXCEEDS the demand
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

abangbikerz
  • Question Question
UW 12 Angle Joints
Replies
1
Views
4K
goutam_freelance
goutam_freelance
YuJie_PV
  • Locked
  • Question Question
An ASME interpretation regarding UW-11(a)(5)(-b)
Replies
2
Views
2K
YuJie_PV
YuJie_PV
YuJie_PV
  • Locked
  • Question Question
the reason of the change with UW-11(a)(4)?
Replies
1
Views
618
XL83NL
XL83NL
MhmdNfri
  • Question Question
ASME Sec. I / NDT / PW-11 / Table PW-11
Replies
2
Views
489
goutam_freelance
goutam_freelance
sshep7
  • Locked
  • Question Question
SA-53 E/B used as a vessel shell Section - UW-12(e) UW-12(d), UW-11(a)(5)(b) and what JE to use
Replies
4
Views
650
david339933
david339933

Part and Inventory Search

Sponsor

Back
Top