Greenleader
Aerospace
Hello. Could you steel minded folks kindly take a look at my thread concerning crystal manipulation in steel using vibration. Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Using vibrations to control stresses and structures in steel
- Thread starter Greenleader
- Start date
- Status
- Thread starter
- #3
Greenleader
Aerospace
No intentions yet. If it is not a just a wild hair on my part, I can ask the company to look into a process as this, but just looking into it right at the moment.
I didn’t realize this was such a controversial subject. Basically with my little bit of experience with low freq stress relief, just me thinking out loud.
It would seem that crystal structures while forming, would be susceptible to sound waves enough to effect structure and alignment, but I am no metallurgist or physicist.
I didn’t realize this was such a controversial subject. Basically with my little bit of experience with low freq stress relief, just me thinking out loud.
It would seem that crystal structures while forming, would be susceptible to sound waves enough to effect structure and alignment, but I am no metallurgist or physicist.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question