Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Use of copper antiseize in NH3 systems

Status
Not open for further replies.
qualitypro

qualitypro

Mechanical
Joined
Sep 30, 2003
Messages
91
Location
US
I would like to know if there are any restrictions in the ASME codes or industry practices to not use lubricants containing copper in ammonia piping systems or service facilities. Is there a potential for any corrosion or cracking due to usage of copper containing lubricants at flange joints?
 
Status
Not open for further replies.

Similar threads

timsch
  • Question Question
Question of scope of ASME BPVC SECTION IX
Replies
1
Views
9K
DekDee
DekDee
T
  • Question Question
Figure 323.2.2-2 (Reduction in Lowest Exemption Temperature for Steels Without Impact Testing) of ASME B31.3
Replies
0
Views
7K
Tommy2025
T
tigny
  • Locked
  • Question Question
repair of scratch on sealing surface of proprietary flanged assembly
Replies
2
Views
3K
tigny
tigny
K
  • Question Question
Calibration of low Pressure - Vacuum Relief valves
Replies
0
Views
942
Kibar Anderson
K
EMANUELE GUERRINI
  • Locked
  • Question Question
ASME I Boiler with 15 PSI Pressure - Can I Use an ASME IV Safety Valve?
Replies
2
Views
881
The Obturator
The Obturator

Part and Inventory Search

Sponsor

Back
Top