Updating a Hole Dimension Table ?

[dtwo]

I have a part drawing that contains many holes that are dimensioned using the hole dimension table.


Holes were added to this part. So is there a way to update the table without having to manually update each item in the table?

 

[Albigger]

No, there isn't any way to update the table.

This is really something I think that should've been fixed by now.

As a policy, when we can absolutely avoid it, we don't use the tables because not only of this, but if the locations of the holes change the table does not update.

 

[jackk]

It's probably faster to delete the old table and make a new one