Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Units not transferring in same format from DesignModeler to Mechanical

Status
Not open for further replies.
johcatrac

johcatrac

Mechanical
Joined
May 3, 2008
Messages
43
Location
CA
In WB, I created geometry in mm. Selected mm on the project schematic for the Model and then when double clicked Model, the Mechanical window opened up but showing the model in meter. Any way to change this to mm? Geometry still shows in mm. Thanks
 
Status
Not open for further replies.

Similar threads

M
  • Question Question
spaceclaim to STEP format, Help needed.
Replies
2
Views
20K
mosenansi
M
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
M
  • Locked
  • Question Question
ANSYS Mechanical Scripting: how to delete an existing heatflux?
Replies
0
Views
811
MihailW
M
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X
IJR
  • Locked
  • Question Question
On how and where to insert command snippets inside Workbench mechanical
Replies
2
Views
1K
IJR
IJR

Part and Inventory Search

Sponsor

Back
Top