matteorivelli
Mechanical
Good morning. in Hypermesh 7 where i can find the menu about the unit of measurement adopted, and how i can modify them ??
thanks.
thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
unit of measurement
- Thread starter matteorivelli
- Start date
- Status
GregLocock
Automotive
The scaling is implicit, so far as I remember.
That is, if you use consistent units for all your dimensions and properties then the answer will be correct.
Cheers
Greg Locock
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips.
That is, if you use consistent units for all your dimensions and properties then the answer will be correct.
Cheers
Greg Locock
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips.
- Status
Similar threads
- Locked
- Question
- Locked
- Question