Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

UDL over a 3rd of a inner diameter?

Status
Not open for further replies.
l354uge

l354uge

Automotive
Joined
Mar 1, 2017
Messages
1
Location
GB
Hi all,

I need to apply a UDL over a 120degrees of the inside face of a circle. I've managed to do 180 for another load case thanks to how the surfaces were imported, but dont know how to apply it to 120degrees?
 
Status
Not open for further replies.

Similar threads

Nir_k
  • Locked
  • Question Question
How to select both the exterior and interior surfaces (All Entities) of an element when creating surfaces in Hypermesh?
Replies
0
Views
2K
Nir_k
Nir_k
Sayed Ghalleby
  • Locked
  • Question Question
Modal analysis and effective mass fraction modification
Replies
1
Views
1K
GregLocock
GregLocock
mpvnaresh
  • Locked
  • Question Question
Hi.. I am working on a structura
Replies
0
Views
520
mpvnaresh
mpvnaresh
Beider
  • Locked
  • Question Question
Modeling HDPE with upper and lower yield points and >300% strain - RADIOSS
Replies
1
Views
726
hiper_88
hiper_88
mj345
  • Locked
  • Question Question
Altair Hyperview/Hypergraph- ratio of ALLSD to ALLIE
Replies
0
Views
187
mj345
mj345

Part and Inventory Search

Sponsor

Back
Top