Unable to uncheck FEM mode

[venkataramu]

Dear Friends,


I am Ramu working on ProE WF2. I am learning Pro/Mechanica. When I selectthe structural analysis, by default it shows FEM checked. I am unable to uncheck the FEM mode. Why it is happening like this. Please help me regarding this


Thanking you


Ramu

 

[FDdesign]

ISRAR, described in the pastwhat you should do when that happens. (Answer 06 October 2004)

See http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=25 379&KW=mechanica+directory+ptcsetup .

Regards,
FDDesign
Edited by: FDdesign

 

[james.lynch]

Hi Ramu,


on installing ProE, under "interoperability Settings" you need to point to the path where Mechanica is installed..


there a a few posts on the forum about this already, do asearch - it's very good!

if you are still stuck, post back!


hope this helps,


James


HA! beaten by a minute!

Edited by: james.lynch

 

[venkataramu]

Thank you friends. I got Mechanica in WF2.0.


In proE2001 where can I set the path for Mechanica.


Please help me regarding this. I am confusing


Ramu