I am trying to use electronic epoxy potting material in a two part mold. I am having problems finding a material that will act as a seal and not stick to the epoxy along the seam. Does anyone have any experience doing anything like this? I am currently testing a silicone rubber mold any recommendations?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Two Part Mold Seal
- Thread starter vctech
- Start date
Similar threads
- Question
- Question