Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Turning Pop-Up Boxes Back On? 1

Status
Not open for further replies.

GARYM

Mechanical
Joined
Apr 7, 2001
Messages
1
Location
GB
While working in MD 5 I lost my pop-up boxes and now get just the text at the bottom - does anyone remeber how to turn these back ON?

Thanks
 
I believe if you go to the command line and type attdia <return> 1 <return> should do the trick. Steve Smith
Product Engineer
Staco Energy Products Co.
 
Type in cmddia (it stands for &quot;command dialog&quot;) at the command line. Then enter 1 (to turn them on) instead of 0. This sometimes gets set to 0 if MDT is interrupted in the middle of a command or routine.

Ron Morin
GSFE, Inc.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top