Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

TRIM SOLID ABAQUS

Status
Not open for further replies.

Jeb_46

New member
Joined
Sep 26, 2017
Messages
3
Location
IT
Hi to everyone,
I have to trim a 3D solid with cylindrical geometry, in order to mesh a quarter of solid.
I have to put symmetry constraints on the cut surfaces.
which is the correct procedure for trimming the part?

thank's to all.
 
If my understanding is correct, then a simple Cut -> Extrude would be enough to cut away 3/4 of the part.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top