Abaqus-Isight

[vikram manoj]

Hi all,

I am analyzing low-velocity impact on composite materials and performing reliability analysis by varying the elastic and strength properties of the laminate as random variables. I am using a VUMAT subroutine in Abaqus. However, when I load the input file into Abaqus Isight, the material properties defined under User Material are not visible for parameterization. How can I resolve this?. Additionally, during execution, I use the following command: "abaqus.bat input=second job=second user=impact.f interactive" but it results in an error. What is the correct way to run this analysis?. Please help me address these two issues.

Thanking you
N.Vikram manoj kumar

 

[FEA way]

What version of Isight are you using ?

If you have access to Dassault Systemes Knowledge Base, check the article "Running Abaqus jobs with user subroutines in Isight".

but it results in an error

What is the error message ?

 

[vikram manoj]

What version of Isight are you using ?

If you have access to Dassault Systemes Knowledge Base, check the article "Running Abaqus jobs with user subroutines in Isight".


What is the error message ?

it says The following file(s) could not be located: impact.f.